This website and all content is copyrighted. If you want to add privacy slats in the future, make sure the frame work will be strong enough for additional wind load. You may want to use longer line or terminal posts depending on the wind and soil conditions in your area. Depending on the wind and soil conditions you may want to use 8' centers or even a more narrow spacing for line posts. Notes: Post depth can be determined by local weather and soil conditions, terminal posts are normally dug 10" wide and 18" to 30" deep. Help installing chain link fence on a slope. Double gates use the same procedure but install center latching device (fork latch). Adjust and tighten hinges to allow for full swing. Set gate in place, aligning top of the gate with the top of fence. This will prevent the gate from being lifted off. One picket shown in red is turned until the fence is separated.Īfter the fence has been completed, install the male hinges to one of the gate posts, hanging the top hinge with pin pointing down and the bottom hinge with the pin pointing up. Twist the wire in a corkscrew fashion until the fence comes apart. To remove excess chain link fence fabric - untie both top and bottom ends of fence (knuckles - pliers shown below). Now you shouldn't even be able to see where the two sections were connection together. Join and tighten the knuckles at bottom and top. Join the two sections by winding (corkscrew fashion) the loose strand down through the fence. Place the two section of fence next to each other (end on end). To connect two sections or rolls of fence fabric together - take a single strand of wire from one of the sections of fence (Sometimes it is necessary to remove a second wire on the one end in order for the two sections to mesh properly.). Loosely attach fabric to top rail with a few wire ties. Walk along the fence and take the slack out. Use the carriage bolts with the head to the outside of the fence. Fasten the tension bar (that you just inserted) to the terminal post with tension bands (already on the post). Stand the fabric up and lay it against the posts. Slide tension bar through the last link on the chain link fabric. Unroll the chain link fabric on the ground along the fence line. Check with level to make sure posts are straight. Top of the line posts should be even with the string. Before concrete begins to set, adjust post height by moving post up or down. Next, dig the holes.ĭig the post holes and set the line posts. Usually walk gates require 3 3/4" for hinges and latches and double drive gates require 5 1/2". Step 2 - Locate and set Terminal Posts (corner, end, and gate posts are called terminal posts)ĭistance between gate posts is determined by adding the actual width of the gate plus an allowance for hinges and latches. This is easily done by stretching a string along the property line and setting the posts 4" inside. This will help avoid encroaching on adjoining property with concrete footings. Most fence installers recommend that all posts be set approximately 4" inside the property line. Use 4 per tension bar or 1 per foot of fence heightġ for every 12" of line posts and 1 for every 24" of top railĢ per single walk gates and 4 per double drive gateīe sure that the fence does not exceed property lines. Use 1 per tension bar (holds rail end in place) Use 1 for each end or gate post, 2 for each corner post Use 1 per line post (two styles shown left) Terminal Posts (end, corner, and gate posts) (usually larger than line posts)ġ for each length of plain top rail. Total footage of fence less gate openingsĭivide total footage by 10 and round up (see chart below) Materials Needed for Residential Chain Link Fence
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |